粘箱机日常维护常识 Common sense of daily maintenance of gluing machine

1、更换纸箱包装机械的蜗轮蜗杆减速箱内的润滑油，润滑油可选用10号、20号或30号机油。

　　2、各部件修复后进行全机组装，开机运转，观察机器运转是否正常。适当加热滚筒，并投入少量纸箱包装机械专用油，使其熔化覆盖筒体内表面，然后切断所有电源。必要时可对机器外表补喷油漆，干燥后用塑料纸覆盖，置干燥场所保存。

　　3、链条若过松，可先采取去掉几节的方法进行调整，若已严重拉长，则应更换。在使用纸箱机械时要按照一定的额方式和原理进行使用，按照一定的方式进行保养和维护，及时解决不同的故障问题，调整和更换链条时应注意：链条接头处弹簧卡片的安装方向应与链条的运转方向一致，以免运行时产生冲击、跳动，甚至碰撞脱落。

　　4、对所有滚动轴承进行拆洗，并加注新的润滑脂，可采用钙钠基润滑脂。

　　5、清除所有摩擦面上的污垢，尤其是对链条和链轮要进行清洗，重新加注润滑油。

　　纸箱包装机械的保养和维护修要一定的技术人员进行维护和修理，保证纸箱机械在使用中的质量和性能，在生产纸箱中发挥重要的作用和价值。

1. Replace the lubricating oil in the worm gear reduction box of carton packaging machinery. The lubricating oil can be No. 10, No. 20 or No. 30 engine oil.

2. After all parts are repaired, assemble the whole machine, start the machine and observe whether the machine operates normally. Heat the drum properly and put a small amount of special oil for carton packaging machinery to melt and cover the inner surface of the drum, and then cut off all power supply. If necessary, the surface of the machine can be sprayed with paint. After drying, it shall be covered with plastic paper and stored in a dry place.

3. If the chain is too loose, it can be adjusted by removing several sections. If it has been seriously stretched, it should be replaced. When using carton machinery, it should be used according to certain methods and principles, maintained and maintained according to certain methods, and different fault problems should be solved in time. When adjusting and replacing the chain, it should be noted that the installation direction of the spring card at the chain joint should be consistent with the operation direction of the chain, so as to avoid impact, jumping, or even collision and falling off during operation.

4. Disassemble and wash all rolling bearings and add new grease. Calcium sodium base grease can be used.

5. Remove the dirt on all friction surfaces, especially the chain and sprocket, and refill the lubricating oil.

The maintenance and repair of carton packaging machinery should be carried out by certain technicians to ensure the quality and performance of carton machinery in use and play an important role and value in the production of cartons.